1Which of the following states the 80/20 rule of end-to-end VLANs? 80% of network resources should be remote and 20% should be on the local VLAN. 80% of VLANs should be static and the remaining 20% should be dynamic. *** 80% of network traffic should be local and 20% remote. 80% of the network sources should be centralized at…
1What information does frame tagging add to each frame to allow delivery of frames across a switched trunk? the destination MAC address the switch MAC address *** the VLAN ID the BID 2 Switch1 is not participating in the VTP management process with the other switches shown in the graphic. What are the possible reasons for this? (Choose two.) Switch2 is…
1 Refer to the graphic. Server sends an ARP request for the MAC address of its default gateway. If STP is not enabled, what will be the result of this ARP request? Router_1 will kill the broadcast and reply with the MAC address of the next hop router. Switch_A will reply with the MAC address of the Router_1…
1What is the default setting for the mode LED on a switch? *** STAT FDUP UTIL 100 PORT 2An old workstation has been replaced with a new one. The workgroup switch is not learning the MAC address of the new workstation. A network technician has verified that a static MAC address is not configured on the attached switch port. Which…
Which of the following are requirements of LAN design? (Choose three.) *** adaptability *** manageability operability *** scalability stabilityWhen designing a LAN, at which layer of the OSI model does the process of segmenting collision domains occur? Layer 1 *** Layer 2 Layer 4 Layer 7Which of the following affect network availability? (Choose three.) *** throughput *** response time workstation speed *** access to resources desktop applicationsWhat type of…
1Which attribute is used by a bridge to make forwarding decisions? source IP address source MAC address destination IP address *** destination MAC address Layer 4-7 protocol address 2What is the effect of adding additional hosts to a half-duplex Ethernet network? (Choose three.) *** collisions increase collisions decrease *** jam signals increase jam signals decrease *** throughput decreases throughput increases 3How does an Ethernet bridge handle…
1Why would it be necessary to configure the bandwidth setting on an EIGRP interface rather than leaving it at the default setting? (Choose two.) *** A suboptimal route may be chosen as the best path to a destination if the bandwidth setting is higher than the actual bandwidth of the link. *** The network may be unable…
1What does OSPF use to calculate the cost to a destination network? *** bandwidth bandwidth and hop count bandwidth and reliability bandwidth, load, and reliablity 2A network administrator has configured a default route on Router_A but it is not being shared with adjacent Router_B and the other routers in the OSPF area. Which command will save the administrator the…
Bu sinava bizzat girdim %93 aldim 2 bos biraktim ve 1 yanlis… Umarim sizelere de yardimci olur bu cevaplar1 Refer to the exhibit. What will be the result of DR elections in the OSPF network shown? (Choose three.) *** R1 will be DR of the 192.168.4.0/24 network. R2 will be DR of the 192.168.4.0/24 network. ***…
As IP subnets have grown, administrators have looked for ways to use their address space more efficiently. This page introduces a technique called VLSM. With VLSM, a network administrator can use a long mask on networks with few hosts, and a short mask on subnets with many hosts. In order to implement VLSM, a network…