Bilgisayar

3.3 Quiz Cevaplari

1Why would it be necessary to configure the bandwidth setting on an EIGRP interface rather than leaving it at the…

7 ay ago

3.2 Quiz Cevaplari

1What does OSPF use to calculate the cost to a destination network? *** bandwidth bandwidth and hop count bandwidth and reliability bandwidth, load, and…

7 ay ago

3.0 Final Cevaplari

Bu sinava bizzat girdim %93 aldim 2 bos biraktim ve 1 yanlis... Umarim sizelere de yardimci olur bu cevaplar1 Refer…

7 ay ago

2.0 Final Cevaplari

Which of the following could describe the devices labeled "?" in the graphic? (Choose three.) **DCE**CSU/DSULAN switch**modemhub-------------------------------------------------Router A and Router B…

7 ay ago

2.0 Practice Final Cevaplari

Arkadaslar bu sorularin cozumleri henuz elimde mevcut degil bos bir zamanimda cozup cevaplari da yayinlamaya caliasacam ancak simdilik sorularla yetinin..1…

7 ay ago

2.11 Quiz Cevaplari

1 Assuming the ACL in the graphic is correctly applied to an interface, what effect will the ACL have on…

7 ay ago

2.10 Quiz Cevaplari

1 A computer programmer is developing software that requires a reliable stream of data. Which protocol can be used in…

7 ay ago

2.9 Quiz Cevaplari

1 Which ICMP message type notifies source hosts that a receiving host or network is not available?time exceededredirect*** destination unreachablesource…

7 ay ago

2.8 Quiz Cevaplari

1 Which layer protocols provide reliability for IP when needed?ICMP and ping RIP and TTL *** upper layer protocols *lower…

7 ay ago

2.7 Quiz Cevaplari

1 If the passive interface command is enabled on the fa0/0 interface of Router E, which statements are true? (Choose…

7 ay ago